http://forum.infiniteautomation.com/forum/posts/list/3.page JForum - http://www.jforum.net
I bought a MS - TC Temperature and current sensor from Homechip.com, Link = http://www.homechip.com/catalog/product_info.php?cPath=27&products_id=73.

This is based on a DS2438 chip which Mango recognises fine but its reading voltage not amps or even watts which is what i need to make use of the data.

The blurb on the site says that the output the MS-TC will measure AC current in the range of 0 to 20 amps. While not calibrated, empirical data indicates a typical accuracy of ±3% of reading. The response curve, established at 23 degrees C, is linear from 0.2 VDC (1 amp.) to 3.78 VDC (20 amps.). The zero current reading is 0.09 VDC.

Is this something you can add to the setup ?

Cheers


Keith]]> http://forum.infiniteautomation.com/forum/posts/preList/70/300.page http://forum.infiniteautomation.com/forum/posts/preList/70/300.page GMT http://forum.infiniteautomation.com/forum/posts/preList/70/305.page http://forum.infiniteautomation.com/forum/posts/preList/70/305.page GMT
Thanks


Keith]]> http://forum.infiniteautomation.com/forum/posts/preList/70/311.page http://forum.infiniteautomation.com/forum/posts/preList/70/311.page GMT