I18N Localization

I have a problem that I'm dealing with right now.

I've set up a modbus data source to read and set a setpoint.
I multiply the read value by 0.1 to get the right value.
This works fine in most cases but sometime the vale comes up with a lot of decimals (eg. 1.00000001).
This looks bad on Graphic views.
The solution I used for that is the Text renderer properties where I set the format to 0.0
The value comes up with 0,0 because I'm using a non US computer.
Next problem is when I'm setting a new value.
The setpointbox shows the value with a comma as decimalpoint but Mango doesn't accept values with , (comma). It only accepts . as decimal separator.

This get somewhat confusing for users.

Personly I don't mind using point as decimal and it would be better not to localize the decimalsign because unformatted values are shown with point.

Is there anyone who have a better solution for this?

Thanks

Hi pegi,

This is actually a known problem. The only workaround right now is to do as you are doing. My apologies to your users.

This message was edited 1 time. Last update was at 28/01/2010 19:58:08

sorry, wrong message